vacuum pump unit of anti corrosion method
As the name suggests, the vacuum pump unit needs to deal with water frequently, so in order to make the equipment work normally, anti-corrosion measures must be taken for the equipment, otherwise long-term contact with water will easily cause corrosion impact on the equipment itself. So how to take anti-corrosion measures for the equipment?
1. First treat the surface: clean the oxide layer on the surface and clean the surface with acetone.
2. Blending material: mix in proportion and stir evenly until there is no color difference.
3. Coating material: first apply a thin layer of material, pay attention to ensure tight bonding and complete coverage, and then apply the material evenly to the repaired and protected parts of the vacuum pump unit, and reach a certain coating thickness. The thickness of the repaired and protected coating shall meet the requirements of the fit clearance between the impeller and the disc.
4. Curing: curing after heating for 24 hours / 24 ℃ (material temperature) can improve the overall stability of the material, but the lifting temperature shall not exceed the bearing temperature of the material.
Therefore, when you need to make an anti-corrosion coating for the vacuum pump unit, you can treat it according to the method mentioned in the above small series, but you should pay attention to the correct anti-corrosion treatment method, otherwise it will not have a good anti-corrosion effect.
(The article comes from the Internet. If reprinting is not allowed, please contact our company to delete it.)