Whether you work in a refrigerator, a car, or a lab, using a vacuum pump to remove unnecessary air and liquid from a machine can be good for your business.
But what is a vacuum pump? How do they work? I think having a vacuum pump around will benefit you in the long run, especially if you have been using a method to absorb pressure just by a can and a tube.
Although this method is how much residents with a beginner’s knowledge of automotive mechanics will generally work, vacuum pumps help speed up the exhaust brake and repair the air-conditioning system process.
Since I have to spend a lot of time with these vacuum pumps, I can give you the best information about the best vacuum pumps on the market today.
Safety operating rules for vacuum pump user guide
Do not pump flammable or explosive gas or vapor, or operate the pump in or near an area containing flammable or explosive gas or vapor.
Do not operate in the area where the spray product is being used.
Do not operate this product near fire source.
It can only be used indoors.
Do not operate in areas where the pump may fall or sink into water or any other liquid. If this product falls into the liquid, do not touch it. Unplug the power immediately.
Vacuum pump user guide warning
Before use, check hoses, plugs and wires for signs of damage. If found insufficient, please do not use. Do not operate equipment that has fallen, damaged or fallen into water. Contact us for information; For more information, see the technical support section.
Please keep the wire away from the heated surface.
Do not block the vents on the housing and keep them free of dust and foreign matter.
The pump has a disposable (fuse) type overload protector. If the motor overheats, the protector will turn off the device. If this happens, unplug the pump and contact technical service.
Only for pumping air or gases, not liquids or particles. If large amounts of liquid or particles enter the system, they may damage the pump or degrade performance. If avoid forming condensed water in the pump, can extend the service life of the pump. The vacuum well should be emptied after each use.
Guide for vacuum pump installation and use
The vacuum pump shall operate in a clean, dry, well-ventilated area at a temperature between 5-40°C (41-104°F). This is especially important when the equipment is installed in a narrow space. Protect external parts from direct or indirect moisture contact. Avoid operating the pump in dusty conditions.
To prevent liquid or vapor from entering the pump when vacuum is applied, install the Millex ® -FG 50 line filter flask and filter between the pumps. Alternatively, the pump can be protected with a flask vacuum well consisting of a 1-liter filter flask, a no. 8 plug, and a silicone tube. When using vacuum flask traps, it is not necessary to use the Millex ® filter. For best results, keep the line between the pump and equipment as short as possible. Additional pipes can be used as cats.
If possible, kindly suggest please your working industry/process, working pressure, working medium, etc. Given detailed request helps to gain better-matched customized solution. Thanks for your patience.
your request will be responsed within 3 hours, kindly pay attention to your email please.