How to solve the problem of axle holding of 2BV vacuum pump
In the working process of 2BV vacuum pump, the compression process of gas is isothermal, so when compression and suction of explosive gas, it is not easy to occur danger, so it is more widely used. However, the problem of axle holding is easy to occur during use. How should we solve it?
The problem of holding axle of 2BV vacuum pump mainly starts from the bearing components. The specific reasons are as follows: there are differences in the quality of the bearing itself, or wear and aging caused by long-term operation. In the assembly process, the bearing positioning and design requirements are different, the positioning is not accurate, the selection of components is not reasonable, and the quality of lubricating oil is also related to the occurrence of this situation, If the overall vibration of the pump is too large, it is also caused by this reason.
When the 2BV vacuum pump has shaft holding, you should first check which part caused it, and then solve it, so as to make a good overall use.
All the reasons described above are the problems that lead to the axle holding phenomenon of 2BV water ring vacuum pump. The user can judge which component is responsible according to these conditions, so as to make a remedy in a short period of time without hindering the normal production and operation. If there is still something unclear about this, the user can contact our company for guidance in time.
