Vacuum pump for CNC cutting machine
With the rapid development of panel furniture, the cutting-off machine has become an indispensable equipment. The cutting-off machine is composed of some high-end accessories, but these accessories will produce some problems in the process of continuous operation.
In fact, the adsorption force of panel furniture opener has a lot to do with the water-cooled vacuum pump. If there are details and they are not used correctly, there will be many problems
The use of vacuum pump in CNC cutting machine
1. Start the motor fan for the first time to prevent jamming (this step is OK, because the factory will check this point, and the general problem is not big)
2. Before starting the vacuum pump, make sure that the valve is fully opened and the water has been injected into the pump.
3. The suction port and the absorption port of the opening machine shall be strictly sealed to prevent air leakage.
4. The liquid ring vacuum pump must be equipped with a vacuum cover to prevent impurities from entering the pump.
5. Please clean the water tank, water inlet pipe and change the water within 150 days after using the vacuum pump; if not used for a short time, please close the water inlet valve of the water tank and drain the water in the water inlet pipe. If it is not used for a long time, please thoroughly prevent the water in the water pipe and pump head from rusting and affecting the operation.
(The article comes from the Internet. If reprinting is not allowed, please contact our company to delete it.)