Roots blower oil change procedure

Roots blower transport medium for clean air, clean gas, sulfur dioxide and other inert gases, special gas industry (gas, natural gas, biogas, carbon dioxide, sulfur dioxide, etc.) and high pressure working conditions of the preferred products. In view of the above characteristics, it can be widely used in the fields of metallurgy, chemical industry, chemical fertilizer, petrochemical, instrument and building materials.

The maintenance of Roots blower during normal use is very important. As long as you pay attention to the daily maintenance of Roots blower, there will be no problem. When will the roots blower change oil? What should be paid attention to in the maintenance and oil change of Roots blower? The following EVP vacuum pump manufacturer will give you a detailed introduction:

1. Gear oil change sequence of Roots blower:

First, remove the gear oil, and then inject new gear oil. The first time: after one month of start-up operation, replace it after three months, and replace it once every half a year after long-term operation. Pay attention to the oil level and replenish it in time.

2. Evaluation of lubricating oil quantity of Roots blower:

The oil quantity of each type of Roots blower can be checked at any time to keep the oil level between the center line during shutdown. If the oil level is lower than the middle position, the lubricating oil must be added in time; if the oil level is higher than the middle position, the oil temperature will be high, the exhaust body will spray oil, and the engine body will leak oil.

3. Storage of lubricating oil for Roots blower:

After the gear oil is injected, the remaining gear oil shall not be directly exposed to the outside world, so as to prevent other pollutants from entering the barrel and causing oil pollution; secondly, the oil products shall be far away from the fire source and fire-fighting equipment shall be placed. After use, tighten the sealing cap to keep the oil tank sealed. The new oil and waste oil should be placed separately. The container containing waste oil should not be filled with new oil to prevent pollution.