Anti fouling piston vacuum pump

The high anti pollution piston vacuum pump is especially suitable for the vacuum environment with heavy pollution such as ceramic mud mill and metallurgical vacuum furnace.

anti fouling piston vacuum pump advantages:

Anti pollution piston vacuum pump mechanical movement system is the introduction of international advanced technology – oil rotary cam design, the use of the world’s top motion technology, rotary pressure air principle, law of lubrication and law of inertia, and the use of two-stage dual cooling and lubrication, so the motor power is only half of the same speed of reciprocating pump and vane pump, with good lubrication and balance performance It is characterized by large displacement, no friction, low noise, long life and low operating cost.

The vacuum pump body and other main parts are made of high-grade cast iron and made by advanced equipment and technology, such as wear-resistant and high silicon drying, vacuum casting, surface treatment and one-time clamping of machining center. It has the characteristics of low oil consumption (rapid oil / gas separation, extremely low oil content in waste gas), small vibration, high precision and less maintenance.

The “O” ring seal is used between the cover and the body of pump a and B, which has reliable sealing performance, convenient disassembly and repair. The seal between the pump chamber and the bearing is added to improve the service life of the bearing; the sliding valve oil and bearing lubricating oil of the slide valve pump are supplied separately; the shaft sleeve is added between the shaft and the seal to solve the later maintenance cost and improve the service life of the pump.

The structure of the oil tank is at the back of the pump, and the oil layer on the exhaust valve is very thin, which reduces the amount of oil injection during large exhaust, and adds a cyclone oil-gas separator on the side to further reduce the fuel injection amount of the pump during the large exhaust, with little pollution; in the working environment with high water content, the exhaust process has less contact with vacuum oil, the oil emulsion time is longer, and the service life of vacuum oil is improved The oil tank of the piston vacuum pump is located at the back of the pump cavity to prevent the vacuum oil from returning to the pump cavity, which will cause difficulty in starting; and there is a cleaning port on the side of the oil tank to facilitate the cleaning of the oil tank; the machine is equipped with oil-gas separation and oil-water separation devices, which solves the problem of moisture in the gas extracted from the ceramic industry. The vacuum pump keeps a low temperature for a long time under the action of water cooling, air cooling and cooler of pump oil external oil tank, so that the pump oil maintains good lubricity and sealing property. The oil / water separation effect of the pump is good, and the pump oil is not easy to be emulsified and kept pure for a long time after filtration and treatment. Moreover, it can work under severe working conditions and the pump is in good condition Better performance of the characteristics (pump oil can not use expensive vacuum pump oil). It is easy to clean or replace the oil filter of slide valve pump.

The series of pumps are single-stage and single cylinder vertical structure design, easy to install and dismantle, low power, beautiful appearance, good stability, small occupation area, saving installation space, reliable operation, convenient belt adjustment and oil filling / discharging, easy maintenance and repair.

This vacuum pump is widely used in ceramic (electric porcelain) mud refining, cemented carbide, dyestuff chemical industry, food additives, electronics, vacuum plating, paint, medicine, fine chemical industry and other industries, especially in ceramic (electric porcelain) mud refining, cemented carbide, Dyestuff Chemical Industry and other industries with high pollution.