Dry screw vacuum pump motor disassembly skill
Dry Screw vacuum pump has a strong ability to pump water and remove dust. At the same time, it also has the advantages of good limit vacuum, low power consumption, energy-saving and maintenance free. Compared with the traditional vacuum pump, it has improved several levels. Screw vacuum pump has a very strong market in the future. When using screw vacuum pump, its temperature will continue to rise, which may exceed the temperature barrier. There are many reasons for this phenomenon. Here, we need to stop the machine and dismantle it bit by bit for analysis. Here we will introduce the disassembly method of the equipment.
Dry screw vacuum pump motor disassembly skill:
1. Measure and record the local clearance of rotor before disassembly, and try not to knock with heavy hammer. The removed parts shall be kept properly and shall not be scratched.
2. The reason for the replacement of required parts and components and the detailed record of application status shall be stopped.
3. Clean all parts and trim burrs before disassembling again.
4. The static sealing surface without gasket lining or sealing ring shall be coated with inorganic silicone rubber coating, and then the local clearance of rotor shall be adjusted according to the clearance list.
5. After disassembly, all installation is required, but after reassembly, leakage detection shall be stopped, trial operation and functional inspection shall be stopped in time, and installation and operation can be started only after it is normal.
When the dry screw vacuum pump encounters problems, it should be shut down immediately, turn off the power supply, and then disassemble. This is to protect the safety of personnel and equipment. According to the correct method, the disassembly should be controlled reasonably when using the temperature to reduce the risk caused by too high temperature.
(The article comes from the Internet. If reprinting is not allowed, please contact our company to delete it.)