dry vacuum pump shaft holding causes

The quality of the bearing determines the quality of the dry vacuum pump. Regular inspection of the bearing is a kind of responsibility for the dry vacuum pump equipment.

The shaft holding of dry vacuum pump has great influence on the equipment. We need to know the cause of shaft lock, in order to find a reasonable solution, so as to ensure the use efficiency of dry vacuum pump and reduce the probability of damage.

The clamping problem of dry vacuum pump shaft mainly starts from bearing parts. The specific reasons are as follows: different bearing quality, or wear and aging caused by long-term operation. In the assembly process, the bearing positioning is different from the design requirements, positioning is not accurate, parts selection is not reasonable. The quality of the lubricant is also related to this situation. If the overall vibration of the pump is too large, it will also cause vibration.

In view of the phenomenon of dry-type vacuum pump shaft holding, replace the accessories matched with the equipment, tighten the screw, position accurately, add lubricating oil to lubricate regularly, keep the bearing from rusting, and start the switch should not be too large.

In short, in order to avoid this phenomenon, we need to buy high-quality bearings and locate them accurately, and purchase high-quality lubricating oil to assist dry-type vacuum pump bearings. In this way, we can achieve good operation effect. Moreover, we need to master some maintenance knowledge, which can not only help us solve the problem as soon as possible, but also help us better understand this product.

The reasons described above are the causes of shaft lock of dry-type vacuum pump. The user can judge which component is responsible for it according to these conditions, so that remedial measures can be made in a short time without hindering the normal production and operation. If there is something unclear about this, we can contact our after-sales department for guidance.